Installation
An experienced mason should be used for mantel
installation. Pieces are normally dry-set with plastic setting buttons allowing for
consistent ¼" joints. Dependent upon your situation, the installer may pin, strap or
use latex modified adhesives to adhere the pieces to the substrate. After all stones have
been installed, mortar or grout is tucked into all open joints. Care must be used to
assure that mortar does not dry on the mantel face. Sponge with clean water as grouting
proceeds. If field cutting is necessary, cast limestone can be easily cut with a diamond
blade. After installation is complete, the mantel can be cleaned with Sure Klean Vana
Trol, manufactured by ProSoCo, Inc. at 1-800-255-4255.
Maintenance
Periodic cleaning of your mantel, if necessary, should be
done with soap and water or StandOff rinseless cleaner by ProSoCo, Inc. and a natural
bristle brush. Follow directions provided with cleaner. (Do not use wire brushes of any
type.)
Sealers
All of our products are pre-sealed with Water Seal Natural
Stone Treatment, manufactured by ProSoCo, Inc. This is a siloxane water repellent
developed for limestone to provide deep penetration and long lasting protection without
altering the natural appearance of the products.
Installation
